mirror of
https://github.com/Architeuthis-Flux/Jumperless.git
synced 2024-12-20 11:15:55 +01:00
37 lines
1.5 KiB
Markdown
37 lines
1.5 KiB
Markdown
|
# Probe Kit Assembly Guide
|
|||
|
|
|
|||
|
|
|
|||
|
|
|
|||
|
|
Square holes connect to the Probe
|
|||
|
|
Round holes connect to the Button
|
|||
|
|
|
|||
|
|
|
|||
|
|
Lift the middle tab and solder your favorite button facing
|
|||
|
|
down so it can be pressed by pushing on the bar (pro tip:
|
|||
|
|
stick something in there to keep it down while soldering)
|
|||
|
|
|
|||
|
|
Break off that triangular tab at the end and solder
|
|||
|
|
it to the end of the wires that connect to the Jumperless.
|
|||
|
|
The 2mm pitch header pins should friction fit into the
|
|||
|
|
2.54mm spaced holes 18 and 19 at the top left corner.
|
|||
|
|
|
|||
|
|
|
|||
|
|
Strip the single wire wrap wire (you can use your fingernails)
|
|||
|
|
and lace it through the holes around the needle tip, then
|
|||
|
|
slide the needle under it and flood the whole pad with solder
|
|||
|
|
|
|||
|
|
|
|||
|
|
|
|||
|
|
|
|||
|
|
Remember to bridge those pill-shaped pads with a tiny dot
|
|||
|
|
of solder at the end of the rows connecting to your button.
|
|||
|
|
|
|||
|
|
|
|||
|
|
If pressing the button puts the Jumperless in probe mode
|
|||
|
|
but doesn’t light the LED or sense rows, the Button and
|
|||
|
|
Probe connections are swapped, just turn the connector around.
|
|||
|
|
|
|||
|
|
|
|||
|
|
Or just have fun with it and do it however the hell you want!
|
|||
|
|
I’m a piece of paper, not a cop.
|