diff --git a/docs/lindbergh.conf b/docs/lindbergh.conf
index 7c0e0e3..be1bdc7 100644
--- a/docs/lindbergh.conf
+++ b/docs/lindbergh.conf
@@ -5,24 +5,39 @@
 WIDTH 640
 
 # Set the requested dip switch height here
-HEIGHT 4800
+HEIGHT 480
 
 # Set if the emulator should emulate the rideboard used in the special games here
+# If this is set to 0, then the emulator will route the traffic to the serial device
+# defined in RIDEBOARD_PATH if it has been defined.
 EMULATE_RIDEBOARD 0
 
 # Set if the emulator should emulate the driveboard used in driving games here
+# If this is set to 0, then the emulator will route the traffic to the serial device
+# defined in DRIVEBOARD_PATH if it has been defined.
 EMULATE_DRIVEBOARD 0
 
 # Set if the emulator should emulate the motion board from Outrun 2 SP SDX here
+# If this is set to 0, then the emulator will route the traffic to the serial device
+# defined in MOTIONBOARD_PATH if it has been defined.
 EMULATE_MOTIONBOARD 0
 
 # Set if the emulator should emulate JVS and use the keyboard/mouse for controls.
-# If this is set to 0, the emulator will pass through JVS to the serial device
-# defined in JVS_PATH.
+# If this is set to 0, then the emulator will route the traffic to the serial device
+# defined in RIDEBOARD_PATH if it has been defined.
 EMULATE_JVS 1
 
 # Define the path to pass the JVS packets to
-JVS_PATH /dev/ttyUSB0
+# JVS_PATH /dev/ttyUSB0
+
+# Define the path to pass the rideboard packets to
+# RIDEBOARD_PATH /dev/ttyUSB0
+
+# Define the path to pass the driveboard packets to
+# DRIVEBOARD_PATH /dev/ttyUSB0
+
+# Define the path to pass the motionboard packets to
+# MOTIONBOARD_PATH /dev/ttyUSB0
 
 # Set if the emulator should go full screen
 FULLSCREEN 0