From 37cfa4064312ba7481184d099b1c7bb477881591 Mon Sep 17 00:00:00 2001 From: Kei the Pizza Date: Tue, 30 Aug 2022 23:44:11 +0800 Subject: [PATCH] Update README.md --- README.md | 8 ++++++++ 1 file changed, 8 insertions(+) diff --git a/README.md b/README.md index 1f6ae2b..ce2da54 100644 --- a/README.md +++ b/README.md @@ -50,11 +50,13 @@ I also used the following but these are all totally unnecessary - Masking tape, because I ran out of electrical tape and was too lazy to get a new one from the cabinet - precision tweezer, you most likely won't need this - mini grinder with a bit that can be used to poke holes into the paper, you can use scissors- I just happen to have one already set-up in the vicinity + #### Step 1 - Open up the drum There are 5 screws at the back of the drum, use a Phillips scredriver to remove them. + #### Step 2 - Unplug the don and ka connectors @@ -64,6 +66,7 @@ There are 5 screws at the back of the drum, use a Phillips scredriver to remove These rubber knots are the ones that are keeping the top part of the drum attached to the sensors inside. Use your pliers here, pull a knot up and guide it to the opening of the slot to free it. + Once you've done this to all the knots, you can now slowly separate the top layer of the drum which should reveal the sensors. @@ -72,6 +75,7 @@ Once you've done this to all the knots, you can now slowly separate the top laye By now, you'd see a piece of foam attached to a solid plate. Lift that solid plate up and you should see a thick black foam underneath it. In most guides, they replace this foam with a 1cm thick cork or wood. I assume they just want to make the material less shock absorbent so my take was to add a layer of tape to each side of piece of paper to harden it then make a cut-out to match the original foam's shape and place it on top of the original foam. + @@ -87,12 +91,15 @@ Trace the outline of the foam on top of a paper and make sure to mark the 4 hole Add a layer of electrical tape to the untraced side of the paper and cut-out the shape you've traced. Make the 4 holes and make sure to remove some materical from the center, vertically. You should end up with the following. + After doing so, on the side of the paper that does not have electrical tape, add another layer of tape. I used masking tape because I ran out of electrical tape and then ended up adding another layer of masking tape to it to make the result thicker. + After doing so, you can get rid of the original foam and replace it with the one you've made. + #### Step 5 - Add layers to the ka sensors @@ -101,6 +108,7 @@ Cut of strips of tape to cover the ka sensors. I mostly cut strips enough to cover at least two sensors. I did around 5 layers over-all. If you're getting false-positives then you should strip some off. If you want more sensitivity then just add more layers. +