From 8f4cf42aba85620501ca569e345b9409f3743c8f Mon Sep 17 00:00:00 2001 From: Kei the Pizza Date: Tue, 30 Aug 2022 23:35:51 +0800 Subject: [PATCH] Update README.md --- README.md | 48 ++++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 48 insertions(+) diff --git a/README.md b/README.md index 9c0908e..ac31909 100644 --- a/README.md +++ b/README.md @@ -26,6 +26,11 @@ I decided to open up my drum and see how I'd go about doing things. ### Note The drum used in this mod guide is the original Hori Taiko no Tatsujin switch drum but as long as the mechanism is the same- other drums should be moddable the same way. +I wasn't planning on documenting this until I joked to a friend that I'd do. The pictures here were all taken post mod implementation. + +Also, the workmanship of this mod is horrible. The tapes were cut as if I only had access to a piece of rock and not some refined steel scissor. +I only planned on doing this temporarily but it worked so well that I guess this would be permanent instead. + Also, the drum was in pristine condition prior to me modding it. It started getting scratches because I dragged it around while opening-closing, testing, and fine-tuning my modifications. Please take care of your takacon, I wish I'd at least wrapped the surface of mine prior to modding but oh well. @@ -55,5 +60,48 @@ There are 5 screws at the back of the drum, use a Phillips scredriver to remove #### Step 2 - Unplug the don and ka connectors +#### Step 3 - Undo the rubber knots(? not sure what to call these) +These rubber knots are the ones that are keeping the top part of the drum attached to the sensors inside. + +Use your pliers here, pull a knot up and guide it to the opening of the slot to free it. + + +Once you've done this to all the knots, you can now slowly separate the top layer of the drum which should reveal the sensors. + +#### Step 4 - Add a layer to the thick base foam +By now, you'd see a piece of foam attached to a solid plate. Lift that solid plate up and you should see a thick black foam underneath it. + +In most guides, they replace this foam with a 1cm thick cork or wood. I assume they just want to make the material less shock absorbent so my take was to add a layer of tape to each side of piece of paper to harden it then make a cut-out to match the original foam's shape and place it on top of the original foam. + + + +Flip the solid board back to its original position. + +#### Step 4 - Replace the foam that is somewhat attached to the solid board +After flipping back the solid board, you should notice a piece of foam with multiple holes in it. +Slowly peel that foam away from the board. + +In most guides, they replace this foam with 1mm rubber sheet. We'll replace ours with electrical tape on top of paper. +Trace the outline of the foam on top of a paper and make sure to mark the 4 holes that we'd later need to puncture. + +Add a layer of electrical tape to the untraced side of the paper and cut-out the shape you've traced. +Make the 4 holes and make sure to remove some materical from the center, vertically. +You should end up with the following. + + +After doing so, on the side of the paper that does not have electrical tape, add another layer of tape. I used masking tape because I ran out of electrical tape and then ended up adding another layer of masking tape to it to make the result thicker. + + +After doing so, you can get rid of the original foam and replace it with the one you've made. + + +#### Step 5 - Add layers to the ka sensors +**This was the most trial-and-error inducing part for me** + + + + + + WIP