bemanitools/doc/vigem/vigem-iidxio.md

ViGEm IIDXIO

This application allows you to use any iidxio backend, e.g. iidxio-ezusb.dll, iidxio-ezusb2.dll or iidxio-bio2.dll, to be exposed as three XBOX 360 game controller on Windows.

Thus, it allows you to use a real cabinet with all its IO with any game that supports xinput.

Note: This will not work with games that require Direct Input (dinput), e.g. IIDX Infinitas.

Setup

• Install ViGEmBus
  • Source for compiled binaries: bemanitools-supplement
• Place the following in the same folder as vigem-iidxio.exe:
  • Get a copy of ViGEmClient.dll (or from bemanitools-supplements)
  • Rename your corresponding iidxio-XXX.dll, e.g. iidxio-bio2.dll, to iidxio.dll.
• Run vigem-iidxio.exe so that the config file gets created (on first start)
• Edit vigem-iidxio.conf if needed. Available options are explained in the file

Usage

• Depending on the iidxio implementation used, you might have to do some setup, e.g. flashing your IO board for ezusb or ezusb2
• Run vigem-iidxio.exe and keep it open/running
• To quit the program, hit the TEST and SERVICE buttons at the same time

Input mappings

Cabinet	XBOX Gamepad 1	XBOX Gamepad 2	XBOX Gamepad 3
P1 Key 1	A
P1 Key 2	B
P1 Key 3	X
P1 Key 4	Y
P1 Key 5	Left shoulder
P1 Key 6	Rights houlder
P1 Key 7	Start
P2 Key 1		A
P2 Key 2		B
P2 Key 3		X
P2 Key 4		Y
P2 Key 5		Left shoulder
P2 Key 6		Rights houlder
P2 Key 7		Start
Start P1	Back
Start P2		Back
VEFX			B
Effect			A
Test			X
Service			Y
Coin			Start
TT P1 Up	Thumbstick X axis+
TT P1 Down	Thumbstick X axis-
TT P2 Up		Thumbstick X axis+
TT P2 Down		Thumbstick X axis-

Turntables are either in absolute or relative mode depending on how it's defined in the vigem-iidxio.conf.

Additional Notes For Cabinets (Running on embedded Windows 7):

• Make sure that you follow the instructions exactly from the release page (Prerequisites for Windows 7)
• If you get an error while trying to install KB3033929, re-enable windows update
• If you can't find some of these files, see bemanitools-supplements
• Make sure to ewfmgr C: -commit and reboot after installing the drivers (this only needs to be done once)